Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Kently on November 04, 2009, 05:36:20 PM
-
I am running a SmoothStepper, which may or may not have anything to do with this problem. When I am cutting the machine will sometimes stop for no reason. It is not in e-stop. I can click run and it will start immediately from the point it stopped. Any ideas on what is happening?
-
Do you get any mesages on the SS Diagnostics page when this happens?
Hood
-
Do you get any mesages on the SS Diagnostics page when this happens?
Hood
I looked at the diagnostics page when this happened and didn't notice a message. But then again, I didn't even notice a place for a message. I will look again.
-
Not so much a message box but it has all sorts of messages like IsStill etc see which ones have a check in them when it happens again.
Hood
-
Not so much a message box but it has all sorts of messages like IsStill etc see which ones have a check in them when it happens again.
Hood
I see that the IsStill indicator is on. I guess that tells me that the SS knows it is stopped, but I still do not know why. Anything else I should be looking at?