Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Fastest1 on November 01, 2009, 05:09:35 PM

Title: Nested comments?
Post by: Fastest1 on November 01, 2009, 05:09:35 PM
I drew a part on bobcad, assigned and verified the tool path there and all looked correct. Then when I try to run it on Mach it stops and says "Nested comment found line 9". Isnt line 9 specified as N09? If so all I can see that it says is "N09 Z.1. I cant seem to get it to run from any line. Trying to simulate it on the screen before I turn on the controller.
Title: Re: Nested comments?
Post by: Hood on November 01, 2009, 05:19:15 PM
Line nine will be the ninth line down which is probably not the N09.
What that will mean is there are 2 or more comments on the same line.
Post your code and it should be easy enough found.
Hood
Title: Re: Nested comments?
Post by: Fastest1 on November 01, 2009, 05:49:24 PM
Will you point it out?
Title: Re: Nested comments?
Post by: Hood on November 01, 2009, 05:52:36 PM
(PROGRAM NAME - SHERLINE WAY COVER FRONT PLATE (SLIDING).NC)

Has a comment within a comment (nested)
Will work fine if you remove the () round the sliding
(PROGRAM NAME - SHERLINE WAY COVER FRONT PLATE SLIDING.NC)



Hood
Title: Re: Nested comments?
Post by: Fastest1 on November 01, 2009, 06:06:45 PM
Hood you are the man! Thank you
Title: Re: Nested comments?
Post by: Hood on November 01, 2009, 06:08:34 PM
np