Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: William39 on October 31, 2009, 06:11:28 AM
-
Hello all, :)
I meet a trouble with Mach 3 Version 3.
When I start operating (auto mode), the tool offset compensation isn't took into consideration. That means the green light which indicate that tool offset is "ON" immediately turns "OFF" while I key "START".
I do not meet such issue with old version...
May somebody can help me ?
Thanks very much in advance.
William.
-
Do you have a G43 in your g-code file?
Graham
-
Do you have a G43 in your g-code file?
Graham
Hello Graham,
Up to know, I do not have G43 in my part program...
Maybe I would have to ??
I will add and give feed back soon.
Thanks for your help; William.