Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Tweakie.CNC on October 26, 2009, 09:24:07 AM

Title: Reset Button problem.
Post by: Tweakie.CNC on October 26, 2009, 09:24:07 AM

Up to now, I have always been able to operate the screen Reset Button from my keyboard using the @' key but recently this has stopped happening. I have obviously altered a setting somewhere but cannot find the cure.
Has anyone else had this problem and found the answer ?.

Tweakie.

Title: Re: Reset Button problem.
Post by: Hood on October 26, 2009, 10:04:44 AM

Check the screenset you are using has the @ as a HotKey.

Hood

Title: Re: Reset Button problem.
Post by: Tweakie.CNC on October 26, 2009, 01:41:20 PM

Hi Hood,

Thanks for the reply, it is very much appreciated.

I have checked the screenset, as suggested, and can confirm that the hotkey is enabled for the reset button.
I have concluded that it may not be a screenset related problem as I have two computers running Mach, my internet computer (the one I am using here) and my workshop computer. The same screenset works as expected on this computer but no longer responds to the @ key on my workshop one. I have also checked for different ascii values for the @ key on the different keyboards but the mystery of why it used to work but doesn't any longer still defeats me.

Any further suggestions would be well received.

Tweakie.

Title: Re: Reset Button problem.
Post by: M250cnc on October 26, 2009, 02:14:17 PM

Check that both machines are using the same Regional and Language settings.

Phil

Title: Re: Reset Button problem.
Post by: Tweakie.CNC on October 27, 2009, 06:33:40 AM

Thanks Phil, you got it in one.

Now both computers have the same regional and keyboard settings it is working as it should.

Thanks again.

Tweakie.

Title: Re: Reset Button problem.
Post by: M250cnc on October 27, 2009, 09:25:50 AM

OMG. I finally got something right for a change.

Phil