Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: ligwib on October 17, 2009, 10:16:23 PM

Title: mach pausing during cutting
Post by: ligwib on October 17, 2009, 10:16:23 PM

Hi

Ive got a small problem.

towards the end of the cut (same point every time) the steppers must pause for some reason?
but mach must still thinks its moving, ive tried it on a different driver so it definitely a software problem,

the gcode comes from cambam

thanks

Title: Re: mach pausing during cutting
Post by: Mac The Knife on October 17, 2009, 10:23:30 PM

What version of Mach3 are you running?