Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: PeteW on September 05, 2006, 08:38:42 AM

Title: Config files for Mach3 -->Back-Up Files
Post by: PeteW on September 05, 2006, 08:38:42 AM
Hello,

Finally purchased Mach3.  Since I am very new to the configuration of Mach3 and the files that affect the way Mach3 runs and is configured I would like to back-up ALL the files that Mach3 uses for my set-up.  Since I final have everything working correctly for my Boss5, I don’t want to go through the configuration / set-up again.

A list of all these files would really be great.

Thanks,

Pete W.

Title: Re: Config files for Mach3 -->Back-Up Files
Post by: ynneb on September 05, 2006, 08:42:56 AM
The .xml file found in the mach folder holds your configuration.
Id suggest backing up the whole mach folder though.
Title: Re: Config files for Mach3 -->Back-Up Files
Post by: PeteW on September 05, 2006, 08:47:56 AM
The .xml file found in the mach folder holds your configuration.
....
Would this be the only file needed to back-up if I were to change parameters such that
Mach3 will work with a different driver control?

So, I would be able to just make a batch file to rename this file accordingly when using a different driver controls?
Title: Re: Config files for Mach3 -->Back-Up Files
Post by: HillBilly on September 06, 2006, 02:48:03 PM
If you have special M codes and macropump files (which I now you do) you also need your profile folder.
It will be in the Mach 3 directory and have the same name as your *.xml file.

Darek
Title: Re: Config files for Mach3 -->Back-Up Files
Post by: PeteW on September 08, 2006, 10:18:49 PM
If you have special M codes and macropump files (which I now you do) you also need your profile folder.
It will be in the Mach 3 directory and have the same name as your *.xml file.

Darek

Thanks Darek ... the Uboard is working very well .... and I will not forget to back-up the costume files I got from you.

Pete W.