Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Kently on October 11, 2009, 11:10:27 PM
-
Will there be any problem with using different motor tuning acceleration parameters for the X and Y axis. Just wonder if there would be strange results if, for example, cutting a circle at a high speed or if rounded corners would be asymmetric if Constant Velocity mode is used.
-
You can have different vel and accel on all axis if you like :)
Hood
-
your suspicion that CV will be asymetric is correct. However they have to be quite markedly different before I think you'd notice (depending on your accuracy requirements of course). Personally I prefer to have X and Y accel the same for this reason.