Machsupport Forum
Third party software and hardware support forums. => SmoothStepper USB => Topic started by: eloid on October 11, 2009, 12:33:41 AM
-
I keep getting this error at the frist few lines of movement in my g code all the time !!!!!!!!!!!!!!!!! :o
pc is just run mach3 and keygrabber, but im not using the key grabber or my wire joystick when this happens.
controller freq is 1k....
It a slower pc is this amy problem?
-
I wonder if this a gode issue?..or pc was wondering if anyone wold like to "air test" my gcode, its 3-7 inch ish aplique maybe someone( could air
test it for me( ~25 min of code)... and see if it repaetable on there smooth stepper, Cus my other problem has been the z axis dive down
Now the code has bee software simulaed and does diplace any issues.... how now i cant run it due to the above error
pausing all motion...
let me know.. if anyone could test it.. for me
-
Check out this post i made http://www.machsupport.com/forum/index.php/topic,12565.0.html (http://www.machsupport.com/forum/index.php/topic,12565.0.html)
To make sure it doesn't apply to you
Phil