Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: allanjs on September 04, 2006, 05:07:01 PM
-
Hello all,
I am new to Mach2 and very impressed so far. I have a couple of questions.
Not all keyboard commands are working. In particular "altR" to run program
and "alts" to stop the program. I would like to get to the point where a mouse
is limited in it's use. Also programing M30 or M2 does not rewind the program.
All work when clicking with the mouse.
Thanks for the help.
Al
-
Hello
Please check out Mach3. I think all the hotkeys are working in that version :)
also press enter after the M30 and that should fix it
-
Thanks Brian,
<cr> at the end of M30 fixed it.
I am working with the trial version of Mach2. Is Mach3 available
in a trial version ?
Al
-
Yup it is free to try ;D