Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Ray on October 07, 2009, 10:29:43 AM
-
I installed Mach3 on Vista computer and did the memoryoverride. It asked if I wanted to make a personal startup (not in those words) and I did one with my name. I load (My name)MachMill and everything is fine. Reset is blinking and I click it and it stops. THE problem is when I open the original MachMill and the Reset button flashes, no matter how many times I click it it still flashes. Did I not do something right in install? Ray
-
Go to ports and pins, input, and toggle the active low setting for the E-stop.
-
Thanks Gerry.......Ray