Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: olova on October 06, 2009, 07:25:22 AM

Title: Keygrabber jog's only one axe's...
Post by: olova on October 06, 2009, 07:25:22 AM

Hi. I use keygrabber and a gamepad with two "analog" joysticks, my problem is that i can only jog one axe at a time...

Should it be like that ? With the keyboard i can jog all of them simultaniously...

The gamepad work's perfect when i check it with the controlpanel in windows. It works in Mach3 too, but as i wrote, only one axe at a time...

Sorry for my bad english, but i think u guy's understand.

Thank's from a cold sweden...

Title: Re: Keygrabber jog's only one axe's...
Post by: Chaoticone on October 06, 2009, 05:22:54 PM

Olova, you can only do continuos joggin on more than one axis using your set up if I'm not mistaken. Analog jogging is good for only one axis at a time. Maybe this link will help you get what your after.

http://www.machsupport.com/forum/index.php/topic,1391.0.html

Brett