Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: dfurlano on September 04, 2006, 10:46:28 AM

Title: upgrading
Post by: dfurlano on September 04, 2006, 10:46:28 AM

If I upgrade from 1.8x to 1.9x I assume that I willnot lose any of my tuning?  Thought I would ask before I actually did it.

Also on the FTP site I found the post processor for bobcad called "mach1 for v18" I again am assuming that is the lastest post processor?

Thanks.

Dan.

Title: Re: upgrading
Post by: Brian Barker on September 04, 2006, 01:13:57 PM

You can update and it should be fine :)

As for Bobcad... I think there are others that can help you :)

Title: Re: upgrading
Post by: Hood on September 04, 2006, 02:59:41 PM

What I do before an upgrade is make sure I copy my xml file to a different folder on my drive. So if the worst happens its just a case of pasting it back in the Mach folder and all settings are as before.
Hood