Machsupport Forum
Third party software and hardware support forums. => Promote and discuss your product => Topic started by: Andrew on October 04, 2009, 03:48:11 AM
-
Pleased to announce new website
www.CNCWrapper.com
CNCWrapper V2 is a low cost, easy to use and very fast program which will convert a 2 1/2D or 3D Gcode program into Gcode suitable for 4th axis rotary machining.
Features include Rounding gcode generator, Syntax highlighting and more.
Visit www.CNCWrapper.com to download your demo software. The Demo version will convert and save your code so you can run the code on your machine.
Andrew
-
Thanks for a great and very reasonable (read: CHEAP!) product with some great features, Andrew.
Purchased this morning and I look forward to using when time permits.
Dave
-
Thanks for the comments Dave, I hope you get some good use from it.
Andrew
-
Just sent a paypal payment, looking forward to receive my license.
Jeff
-
Just sent my paypal payment too. My rotary takes the place of my y-axis at present. As soon as my Gecko arrives I will be making it into a true a-asx. And will have a 4 axis machine..... then the fun with mach3 will start all over again..... ;-)
-
Jeff / donrus
Thanks for purchasing CNCWrapper and good luck with your machine build donrus. Mach3 is fairly simple to setup for 4th axis, there is a small section in CNCWrapper help which may help with Mach3 setup.
Andrew