Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Maniac on September 30, 2009, 03:55:22 AM

Title: VB macro & shuttle.
Post by: Maniac on September 30, 2009, 03:55:22 AM

Hello everyone

I am moving the lathe in using MACH3.
This is a question of the VBmacro & shuttle.


I want to make the chamfering of the lathe in using the jog dial of the shuttle.
How can I move the tool by VBMacro ,for direction 45degrees by synchronizing with the jog dial?

Title: Re: VB macro & shuttle.
Post by: ger21 on September 30, 2009, 07:38:48 AM

I don't think you can do that with VB.