Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: marcel beaudry on September 29, 2009, 11:46:46 AM
-
Hello to all
My spindle is reversed when i input m03 it goes anticlockwise and m04 it turns clockwise.
How do i resolve this problem
Thank you for your time
Marcel
-
What type of spindle? How does it connect to Mach? Do you use M3/M4/M5 macros or is it just via the outputs on the spindle setup page?
Hood
-
Hello Hood
i think it goes via the output on the spindle setup page
-
Then sounds like you have the outputs set the wrong way round, just put whatever is set for M3 in the M4 box and M4 in the M3.
Hood
-
Hello Hood
How do i do that
Marcel
-
Go to Config menu then Ports and Pins then Spindle Setup and you will see the boxes for M3 and M4. If that doesnt change things then attach your xml and I will have a look to see how your spindle is set up.
Hood
-
Hello Hood
Problem resolved
Thank you for the advice and your time
Marcel
-
No problem :)
Hood