Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Toad on September 27, 2009, 10:07:22 PM

Title: need asistance
Post by: Toad on September 27, 2009, 10:07:22 PM

Hi Everyone:

When my mill finishes a job, I have it programed to go to "0" the problem is , is that "Z" and "Y" go to zero, bit "X" does not. I have all three set up the same way in the config. settings. Why doesn't "Y" respond? ???

Toad

Title: Re: need asistance
Post by: Chaoticone on September 27, 2009, 10:17:55 PM

Post your code here for us to look at.

Brett

Title: Re: need asistance
Post by: Toad on September 27, 2009, 10:33:37 PM

I would if I could, but it is not connected to the internet, and has no cdr . Old computer, but works fine.  What I did was go into the config homing limits and set "X","Y" and "Z" to go to zero. Is this not correct, or do I need to do something else?

Toad