Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: SailFl on September 27, 2009, 07:06:28 PM
-
I recently had a hard drive failer which required me to reload Mach and my XML file. Version R3.042.029
When I start Mach without my CNC machine on, the status bar has the message, "Nothing to Freehold" and I get a beeping sound. In the past I never had a problem opening Mach with my machine off. I also did not have beeping. I checked the "use Key Clicks" and it does not have a check mark beside it.
It was suggested because of a problem that I am having with my cuts, that I try without using my Shuttle Pro. I went into Config Plugins and tried to disable Shuttle Pro but I get an error message, "Error Found, Art Code: 9991, Attempt Recovery?" If I click OK, the program aborts and I am at my desktop. I have to restart Mach. I have recently loaded the ShuttleProOnoRev program to increase macros. I think the ShuttleProOnoRev is also affecting things.
I even attempted to disable the plugins, Flash, Flash Screen and Video, but in both cases it allows me to leave the plugin screen. I save my configuration. But when I restart Mach and go back into plugin config, they are enabled.
How do I disable my plugins? Why am I not able to control the beeps? What is the story with the freehold? How do I remove the ShuttleProRev?
I could use some answers and help. Thanks
-
Delete the plugins from the plugins folder.
-
Ok, that is how to take care of the plugins. Thanks for that information.
How do I remove the ShuttleProOnoRev part of it?
How do I stop the beeps?
-
I'm not sure if this will help, but my .xml file had some wrong check boxes for the plug ins. I edited the .xml file (using the xml editor) and all was well after that.