Machsupport Forum

Mach Discussion => Brains Development => Topic started by: ReCar on September 22, 2009, 06:24:32 PM

Title: Change G Code
Post by: ReCar on September 22, 2009, 06:24:32 PM

Hi, I use the Mach3 in a manipulator for welding and need it receives information from an external system and change the G code that are running. It is possible to be done through the MachBrain?

I thought about making a single file .txt with different blocks of G code and changes them according to the entry in paralele port. What do you think?