Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: ichikuma on September 03, 2006, 12:04:17 PM
-
Hi,
I've searched the forum and found several other people who have had the estop issue happening randomly. I'm having the same issue and I tried increasing the rebounce setting incrementally, 1000, 1500, 2000. It's still happening so I figured lets go to an extreme, 10000 and then 20000, it's still happening. Does anyone have any other suggestions I might try to keep the machine running?
I've been running the same programs for the last several month and everything has been fine. All of a sudden, yesterday it started estopping for no reason at all.
Thanks for any help.
-
Sound like a bad limit switch, but you could try turning off "Watch dog", "Enhance pulsing" and do a "Adaware" scan.
Check out:
http://machsupport.com/forum/index.php?topic=655.0