Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: SailFl on September 17, 2009, 05:49:20 PM
-
I only started using R3.042.020 within the last two weeks. What I am experiencing, is that I do a "Ref All Home", after that the Z is not Zeroed. Yes, I am looking at the Machine Coordinates. I have even reinitiated the Ref All Home and it still does not Zero Z. X and Y are fine but not Z. I have to restart Mach to get it to work.
With the previous version, I do not remember what that version was, I did not have this problem.
Is this a bug?
Thanks
-
Are you using the parallel port or some other hardware such as SmoothStepper?
Not heard anyone else with that problem and as its been out a while I would have thought if a bug it would have surfaced before now, then again maybe there is something unique about your setup that is making it happen.
If you want to attach your xml I will have a look and see if I can repeat.
Hood
-
Are you saying it works sometimes? Do you have Auto Zero checked in Config>Homing/Limits?
-
Gerry,
Good call. I know before I loaded the new version that AutoZero was checked for Z. And I have not been in there. I would have thought that the new version would have used the old configuration.
Thanks Gerry and Hood.