Machsupport Forum
Tangent Corner => Tangent Corner => Topic started by: mike209 on September 14, 2009, 02:30:46 PM
-
Hi All
I need help connecting my esab esp 50 to mach 3. The esp 50 has a cnc interface board with a connection terminal so it should be simple. But electronics is not my strong suit so I hesitate to experiment. terminals 1) arc-on signal 2) relay closing signal to cnc 3) start signal 4) relay closing signal from cnc 5) 20:1 (+) 6) voltage divider (-) signal to cnc How hook it up to mach 3?
Thanks
lynn212
-
I can't believe you didn't get any help, with all the brain power we have on this forum, But , sorry , I,m not one of them.
If your still having problems , I suggest posting in the Mach disscussion post.
Good luck.
Ed