Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: MechanoMan on September 13, 2009, 01:20:06 AM
-
I was using Mach3 on another computer and when left-clicking on the DRO value for a particular axis, no manual entry window for the Machine Offset shows up. I can click on the Zero X/Y/Z stil, but that only zeroes it, not set it to an arbitrary value. I looked under General Config and don't see anything to turn it on/off though. What keeps this from showing up?
-
On the operator menu you will find "Auto-Calculator"
Greg
-
Yay! That's it, thanks!