Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Digital on September 02, 2006, 06:00:12 PM

Title: PC keeps rebooting after clicking Reset....
Post by: Digital on September 02, 2006, 06:00:12 PM

Heres the deal...

I installed the trial version of Mach 3 on my system to test my new board. Problem is that when i click the (big red) RESET button, my computer randomly restarts for no reason. I have changd a few settings, but nothing has changed.

Any ideas?

Title: Re: PC keeps rebooting after clicking Reset....
Post by: Chip on September 02, 2006, 08:04:24 PM

Hi, Digital

It would help if you could give us more info., computer speed, mem amount, Win 2000 or XP, ver. of mach3.

Have you run the Driver test, or try-ed reloading Mach3   ??.

Title: Re: PC keeps rebooting after clicking Reset....
Post by: Digital on September 02, 2006, 11:26:00 PM

Sorry, you are right....you guys needed more info.


My compter is as follows:
P4 3.0 ghz
1 gig DDR2
PCI parallel adapter
Win XP SP2
Mach 3 (the latest version)


I have reinstalled Mach 3 three times now. It still does the same thing.

Title: Re: PC keeps rebooting after clicking Reset....
Post by: Digital on September 02, 2006, 11:47:59 PM

Now I can't even start the program without my compter reatarting. It's ONLY the MACH  software that does it.  hmmmm.

Doesnt load past the initial screen.

Title: Re: PC keeps rebooting after clicking Reset....
Post by: Brian Barker on September 03, 2006, 07:08:03 AM

In the manual there is a section on uninstalling the driver. Please uninstall the driver and reinstall. Once you have reinstalled please reboot the PC. if you don't reboot you will get this same problem :(

Thanks and tell me if that helps
Brian