Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: TylerQSS on September 11, 2009, 06:02:45 PM
-
Hi,
I'm very new to routing but have experience running a vinyl cutter.
We've got our router up and running and have cut out a few words using lazycam/mach3
The issue were having is the router is rounding parts of letters that should be a 90 degree corner, such as the corners on the top of an upper case L.
I'm not sure where to start with this problem if anyone has any suggestions I would greatly appreciate it.
Thanks,
Tyler
-
Have a read here... http://www.machsupport.com/docs/Mach3_CVSettings_v2.pdf
-
ARE you actuall cutting the letters or just looking at the toolpath generated?
(;-) TP
-
cutting the actual letters, the tool paths all look right with good corners but when cut the corners get rounded.. this is my first day at work since I made the post so I'm gonna try some of the settings sam suggested