Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: kolias on September 11, 2009, 01:28:53 PM
-
The chapter 8 of the Mach3 Mill manual describes importing DXF, HPGL and image files with File / Import
I don't see any Import function on my File menu. Do I read something wrong?
Nicolas
-
Yes, you are reading the old manual ;) To be fair its not been updated where Mach has leaped in bounds so that particular manual is relating to a very old version of Mach.
You used to be able to import but when LazyCAM became included with Mach it was no longer needed.
Hood
-
Yes, you are reading the old manual ;) To be fair its not been updated where Mach has leaped in bounds so that particular manual is relating to a very old version of Mach.
You used to be able to import but when LazyCAM became included with Mach it was no longer needed.
Hood
And I was pulling my hair saying "where in the heck is that import function" lol
Thanks
Nicolas