Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Project guns on September 09, 2009, 08:00:43 PM
-
I am using mach3 on a mini mill to engrave, we have been using the text wizard, but it is not really adequate for our needs. I have gotten a copy of D2NC to use the 4th axis to engrave tubes and ned a program to make text into dxf files. I have autosketch but it doesn't work, is ther some simple inexpensive program for making text dxf files?
-
http://www.dwgtool.com/outline.htm
-
Gerry,
Thanks for the link.
Question... When it converts the text, does it create arcs / circles or break the circular parts of the text into
small lines? ie; the letter "B" will have two arcs in it and not a bunch of lines for the circular parts of the letter
Thanks,
Rich
-
Haven't used it in a long time, but it was polylines with no arcs.