Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Toymanf on September 01, 2009, 01:57:24 PM
-
Hello all. Where specifically can I download mach version r3.042.020 ? This seems to be the most recommended version for current use(with the smoothstepper at least), but I can not seem to find a link to the actual download. I did check the FTP site. If it is there, could someone please paste a direct link?
Thank you,
Frank
-
I use ver 027 on my mill and I think 022 on the lathe. No real reason why I have an older version on the lathe other than no changes have been made which would make the lathe better so not updated.
If you PM me your email address I can send you ver 020 or whatever you want ( have most I think).
Hood
-
Version 020 can be download from the DOWNLOADS link above. I have been using O27 on both the lathe and mill with no problems.
RICH
-
Version 020 can be download from the DOWNLOADS link above. I have been using O27 on both the lathe and mill with no problems.
RICH
You talking about the downloads page? Havent seen it there for a while unless I am looking in the wrong place.
Hood
-
Hood,
I just looked again and it's listed there as the lockdown version.
RICH
-
Rich 029 is the lockdown when I look, try refreshing your browser.
Hood
-
Refreshed and got 029 like you said. ;)
RICH
-
Take it you must be using Internet Explorer, its bad for that, you have to dig into the options to set it to refresh on each new view of a page, if not then you can go a long time and not see that things have been updated.
Hood
-
http://www.machsupport.com/downloads/Mach3Version3.042.020.exe ;)
-
Thank you for the help with this guys!!!
Out of curiosity, where is the directory for that download? In other words, how did you find it.
Thanks again
Frank