Machsupport Forum
Tangent Corner => Tangent Corner => Topic started by: Overloaded on September 01, 2009, 12:00:44 PM
-
Here is a clip from a manual for a servo motor controller.
Below is the character to be entered in the program to command a move to HOME....or ORIGIN.
But....WHERE IN THE HECK IS THE "BAR" THAT THEY MENTION ?
I have a regular ol' keyboard and don't see it anywhere.
Thanks,
RC
-
Shift Backslash?
-
Well I'll be dang.....Thanks Gerry !
There is a scratch through it on mine...makes it look like 2 vertical dashes.
Thanks again,
Russ
-
It's not a scratch. That's how keyboards show it.
Edit: My dell keyboard at work shows it as two lines, but the Microsoft keyboard I'm using now has a single line on it. hmmmm?
-
Yeah...I noticed that too....after looking more closely. I checked a couple others as well...all have 2 lines.
weird
Thanks Gerry
||||||| Russ |||||||
-
All my Microsoft keyboards have one line , all my other keyboards (dell) show it as dashed.
hmmm
ÏÌÍIİĬĨĮļŀȊȴʃʅПῗ‖↑↕↓ who knew....
-
IBM here.......dashes
-
back in my DOS days that was used ot pipe commands.. could not find it back then either ;)
-
Is this what you're looking for.
http://www.cdrummond.qc.ca/cegep/informat/Professeurs/Alain/files/ascii.htm
Yes this is a long time ago but it was working great
Jeff