Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Ray on August 30, 2009, 09:23:20 PM
-
I just downloaded Mach3 off the website onto a desktop computer with XP and 512 Memory. Every tap file I run shows up on the display as a dot in the middle of the display and you can not see the movement as the gcode cycles. Did I do something wrong? ray
-
I just downloaded Mach3 off the website onto a desktop computer with XP and 512 Memory. Every tap file I run shows up on the display as a dot in the middle of the display and you can not see the movement as the gcode cycles. Did I do something wrong? ray
Ray,
Just zoom in - Shift-Drag up and down with the mouse to zoom.
Regards,
Ray L.
-
Thanks Ray L. I will do that. This version has LazyCam as a seperate installation. The one I have on my laptop in the shop (also XP) must be an earlier version. (I haven't looked yet). Ray
-
Also make sure you've enables the axes and set up your motor tuning to some realistic (if imaginary) values, or it may not play. Had this problem on a laptop recently that I was using for simulation only.