Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: andypasko on August 30, 2006, 03:17:08 PM

Title: Mach Turn
Post by: andypasko on August 30, 2006, 03:17:08 PM

How do I perform a finish pass on Mach turn ?   Any help would be appreciated.

Title: Re: Mach Turn
Post by: andypasko on August 30, 2006, 07:18:25 PM

Disregard... i got it to work.

Title: Re: Mach Turn
Post by: gary on August 31, 2006, 12:10:13 PM

Hi there how do you work out your roughing paths

Title: Re: Mach Turn
Post by: andypasko on August 31, 2006, 04:22:50 PM

I use BobCad V20 for the g-code.  Support page on their website has post for Mach3 Turn.