Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: jeffhead on August 25, 2009, 01:48:38 PM

Title: Tool Change
Post by: jeffhead on August 25, 2009, 01:48:38 PM

I added the auqa screenset and now it will not put in the tool change stop to change bits. Has anyone run into to this or can someone tell me what to do to fix this. Thanks Jeff

Title: Re: Tool Change
Post by: ger21 on August 25, 2009, 09:40:39 PM

In general config (top left), how do you have it set for M6? On mine, when you  get to an M6, the Tool # label should flash and say Change Tool when flashing.