Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Jolines on August 17, 2009, 09:25:47 AM
-
Angry Angry Angry Cry Cry
Hi Hood
I need your helps, my problem is:
I want to create very small letters, more or less than 0.3 high, 0.4 long, 0.3 wide. I have toopath in Artcam at its maximum resolution, and when I do my DSLS 3000 Microproto. The letters are created distorted, as if the letters were doubles, look at the photos.
(http://photos4.hi5.com/0103/609/631/k5yqd.609631-02.bmp)
I hope you can help, Thanks
-
I replied to the personal message you sent me 2 days ago, I asked for some information and you have not responded. Now you are spamming the forum with multi posts, that will not get you help.
Answer the questions I asked and also post your code as an attachment and you may get the help you require.
Hood
-
JOLINES,
I deleted your other thread as it duplicated this posting and will only cause confusion.
Provide additoinal info and surely someone will be willing to help.
RICH
-
multiple posts on same topic.. multiple posts on the same topic.... multiples of letters in the wax.. multiples of letters in the wax... i see a pattern here .. i see a pattern here
regards
Chris
regards
Chris