Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: yakfisherman on August 13, 2009, 11:45:38 PM

Title: How to install Dolphin CAD/CAM post processor file
Post by: yakfisherman on August 13, 2009, 11:45:38 PM

Tried to find in forum but no luck.  Can anyone tell me how to install the Dolphin CAD/CAM post processor file I downloaded from the Artsoft web site so that it works with Mach 3 and Dolphin CAD/CAM?

Thanks

Ed

Title: Re: How to install Dolphin CAD/CAM post processor file
Post by: RICH on August 13, 2009, 11:55:56 PM

You may want to try using the Fanuc one and there are specific ones for the lathe that you can download
from the Dolphin site. I don't really remember but the one from this site didn't didn't work very well .
Oh, think you just copy it to one of the directories of Dolphin.
RICH

Title: Re: How to install Dolphin CAD/CAM post processor file
Post by: yakfisherman on August 14, 2009, 10:17:21 AM

Thanks Rich, I'll go to Dolphin site and look for their post processor file and see if info can be found on installing it there. 

Ed