Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: angel tech on August 10, 2009, 11:10:18 AM
-
Hi, i'm in the process of converting a denford novamill to mach3. Everything is progressing well, but i've noticed a small point that doesn't seem right. The readings seem to be in centimetres rather than millimetres. Can this be changed, and i'm in the demo version at the moment does that make a difference.
-
Sounds like you have your steps per mm set incorrectly in motor tuning.
Hood
-
sorted, thanks. ;D