Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Keith on August 08, 2009, 12:25:47 PM

Title: Probe Plug-In. No config/enable line
Post by: Keith on August 08, 2009, 12:25:47 PM
I recently got my probe working using the digitizing wizard. I'm on to the probe plug-in. The plug-in installed but under 'config' there is no line to enable the plug-in which I see in the manual. I'm using version R1.84.001. If I need to update this to include the enable plug-in under config, do I have to save all my values I set up and re-type them all? Thanks,Keith