Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: simpson36 on August 04, 2009, 08:06:15 AM

Title: Has anyone used DMM technology AC servo drive or motors?
Post by: simpson36 on August 04, 2009, 08:06:15 AM

I would like  to add this product to my review, but I am getting nowhere with the initial research as I can find zip, nada  . . . zero on anyone using these products at all.

Their web site is relatively new, I think. They have a new presence on Ebay, but no sales of the complete system yet.

http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=160350909100&ssPageName=STRK:MEWAX:IT (http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=160350909100&ssPageName=STRK:MEWAX:IT)

the ebay link will eventually expire, so here is the comapny web site:

http://www.dmm-tech.com/ (http://www.dmm-tech.com/)


It seems like a no-brainer to snatch these things up, so I'm wondering why these things aren't all over the place.

Does anyone know anything about this setup?

Title: Re: Has anyone used DMM technology AC servo drive or motors?
Post by: NosmoKing on August 04, 2009, 01:48:23 PM

They say 20yrs experience, but I have only come across them in the recent few months, they seemed to be aggressively pushing the product on a few sites.
It needs someone to grab one and test it.  ;D
Nosmo

Title: Re: Has anyone used DMM technology AC servo drive or motors?
Post by: simpson36 on August 15, 2009, 08:34:05 AM

OK, pulling the plug on this product. A little too far out of the mainstream, no interest, and a close read of the docs show a small fixed following error.

Next drives to be reviewed will be CNCdrives models Whale3 and Dugong.  Both were shipped to me yesterday.