Machsupport Forum
Mach Discussion => Mach SDK plugin questions and answers. => Topic started by: Tristar500 on August 01, 2009, 06:23:50 PM
-
I've tried for a couple of days now to get the Add-on
A couple of issues.
Once I put in the required values and try to run a probing routine I get the check probe dialog box and them when I proceed I get a message "previous SEQ not yet complete."
you can click on OK all day and it won't go away.
Tried this on three different computers, same result.
I'm using the latest version of Mach 3 (not the beta)
Tried both Windoes 2000 and xp,
I'm using the add-on, not the wizard. (wizard was good but primitive and very slow)
Any suggestions?
Has anybody had success with this?
Larry