Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: sn96 on August 01, 2009, 12:40:17 PM
-
Hello all, I'm new here. I have been doing a lot of research getting my self ready to purchase the things I need for CNC milling. I want to get a Sherline CNC Mill 5410 with stepper motors and motor controller box. I was wondering if Mach3 is compatible with Sherline's motor controller?
Thanks in advance.
-
Hi, Sn96
Mach3 will run it fine, Sherline cont is a step & dir, Hears the port pin-out's.
DB25 pin out:
1 - Input from EMC (may be ignored in other systems)
2 - X Direction
3 - X Step
4 - Y Direction
5 - Y Step
6 - Z Direction
7 - Z Step
8 - A Direction
9 - A Step
10 - NC
11 - Output to EMC (may be ignored in other systems)
12 - Output to EMC, XYZ home (may be ignored in other systems)
13 - NC
14 - Input from EMC, C1 (may be ignored in other systems)
15 - NC
16 - Input from EMC, C2 (may be ignored in other systems)
17 - NC
18-25 - Ground
Chip