Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: spnar on August 01, 2009, 12:30:25 PM
-
Hi
While cutting a 3d model Mach just closed and the PC preceded to shut down.
This it did twice.
I checked windows settings regarding hibernation etc and all the settings are switched off including screen saver.
I am using Windoes XP.
???
-
That is very strange indeed as I dont think windows can shut down normally if the driver is running. Does windows crash?
Hood
-
Hi Hood
Strange indeed.
The only thing i found was some G00 commands at a very high speed way above what the motor maximum is configured.
I edited these and the problem never came back.
I am trying out Vectric CUT3D using some of the demo files they have and apart from this all looks well.
Spnar ;)