Machsupport Forum

Third party software and hardware support forums. => Mach3 and G-Rex => Topic started by: aluman on July 06, 2009, 04:00:16 AM

Title: G100 problem with 2 motors on Y axis
Post by: aluman on July 06, 2009, 04:00:16 AM

Hi
I have a portal milling machine with Y axis driven by two step motors on each side. If i call it home, or jog manualy, all works ok. Both motors run.
Problem starts when i run any gcode part program, then only one of motors moves, second one stays motionless

Hope you understand, my english is poor

Thanks

Jerry