Machsupport Forum

Mach Discussion => Mach Screens => Finished Screens => Topic started by: giordano on July 02, 2009, 01:00:52 PM

Title: New Interface in Italian and in English for Mach3: Itascreenset V. 2.0
Post by: giordano on July 02, 2009, 01:00:52 PM
Hello to all. I finally finished the new interface in Italian for Mach3. To install unzip the file setup.zip and launch the program setup.exe. Regards, Giordano Cantori.
Title: Re: New Interface in Italian and in English for Mach3: Itascreenset V. 2.0
Post by: robertmonroe on August 12, 2009, 12:01:34 AM
Wheres the link?
Title: Re: New Interface in Italian and in English for Mach3: Itascreenset V. 2.0
Post by: giordano on August 12, 2009, 11:05:58 AM
Sorry .... Here's the link: http://www.machsupport.com/screens/Engscreenset_2.zip
Title: Re: New Interface in Italian and in English for Mach3: Itascreenset V. 2.0
Post by: budman68 on August 12, 2009, 12:49:12 PM
Very nice work -  :)

Dave
Title: Re: New Interface in Italian and in English for Mach3: Itascreenset V. 2.0
Post by: Fab6657 on August 14, 2009, 11:56:18 PM
good mornig,

realy good screen for Mach3.
Thank you.
Title: Re: New Interface in Italian and in English for Mach3: Itascreenset V. 2.0
Post by: hightechkey on September 17, 2009, 11:32:47 PM
Dear giordano
         There is no English translation at Job Control Screen. I see it is in Italian Language. Please translate and modify if it possible. Thank....

High Tech Key
Title: Re: New Interface in Italian and in English for Mach3: Itascreenset V. 2.0
Post by: giordano on September 18, 2009, 07:55:26 AM
Hello High Tech Key. To test, now I installed the translated version downloaded from the link provided and it works perfectly. Giordano
Title: Re: New Interface in Italian and in English for Mach3: Itascreenset V. 2.0
Post by: hightechkey on September 19, 2009, 10:47:30 AM
Dear giordano
         I had already downloaded your Italian English screenset and testing. It is a great work. But you have left some translation for english at Job Control screen. Do you understand what I mean? My english skill is a little bad. So, I upload some picture for this screen. It is also left at "Set step per unit" button in "Setting" mode. I also upload this photo. Please translate and modify for this if you are OK. Thank.

High Tech Key
Title: Re: New Interface in Italian and in English for Mach3: Itascreenset V. 2.0
Post by: giordano on September 20, 2009, 11:34:34 AM
Hello, I'm sorry but I did not understand the problem. I had not noticed this oversight. Thanks for reporting. Attach the file to install updates. After unpacking the archive, rename the file setup.dat to setup.exe. Regards, Giordano