Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: panaceabeachbum on July 01, 2009, 09:53:53 PM

Title: saving spindle auto calibration
Post by: panaceabeachbum on July 01, 2009, 09:53:53 PM

After running the spindle  calibration is there anyway to save the setting so it doesnt have to be run each time mach is launched? I have clicked the save setting box that pops up when done and clicked save settings from the pull down menu  but everytime I launch mach it seems I need to run the spindle auto calibrate routine

Title: Re: saving spindle auto calibration
Post by: Hood on July 02, 2009, 06:46:06 AM

Afraid I have never used the calibration as its servos I have on the spindle but just curious if this is with the SS or PP?
Hood

Title: Re: saving spindle auto calibration
Post by: panaceabeachbum on July 02, 2009, 09:31:38 AM

with smooth stepper, spindle is spot on after I calibrate and good up until I shut down and restart mach , then has to be recalibrated