Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Robhi on June 28, 2009, 04:14:30 PM
-
Hi,
I tried the programme called scorpion that is attached with mach3 files, my mill machine 3 axes goes fast, I finish the file within 4 minutes.
But I tried to do very simple programme that was designed by mastercam x design, my mill goes too slowly, it moves nearly 3mm in 10 minutes.
Is there some thing wrong in my programme?
Robhi
-
What feedrates have you set in your programme and do you use metric or imperial units for Mach?
Hood
-
Hi,
I use metric system and my faderate is 100% I tried to use more than this but acceleration stays the same.
-
Sorry,
it is better that I attache the file itself
-
That has a G21 which makes it metric so thats correct but the feed is only 1.5mm/min so its going to crawl. You will have to specify a faster feed when doing your part in the CAM programme.
Hood
-
Hello,
Thanks Hood, as well as all of you
I did as you said, you are right. I did so and everthing is fine...
Changing the feedrate in mastercam, that was the problem.
Thanks again
Robhi