Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: johnrc101 on June 21, 2009, 08:51:44 AM

Title: file import
Post by: johnrc101 on June 21, 2009, 08:51:44 AM

can anyone tell me how to import a dxf or jpeg file into mach 3.

Thanks

John

Title: Re: file import
Post by: Hood on June 21, 2009, 09:03:18 AM

You will need to use LazyCAM.
Hood

Title: Re: file import
Post by: RICH on June 21, 2009, 08:24:06 PM

John,
Additionally, if you are going to use LazyCam or LazyTurn, you may want to take a look at some of the manual's
or tutorials located in the Member's Doc section of this site.
RICH