Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: John W on June 20, 2009, 10:56:40 PM

Title: Help with the wizards
Post by: John W on June 20, 2009, 10:56:40 PM

I hope this isn't one of those real "doh!" questions as it my first on this forum but here goes.  I just finished downloading Mach3 and configuring it for my system.  Its a TAIG mill and I haven't completed the installation of all of the electronics package yet.  Without being connected to my controller or anything else for that matter, I wanted to try out the wizards and see how they function but every time I run one and try to enter a number into one of the variable boxes it initially accepts the number but then it reverts back to its original entry as soon as I go on to another box.  It won't accept any input from me what so ever.  These are the wizards that come with Mach3 and not the add-on wizard package you purchase.  Sometimes with demo's they won't run everything until you buy it so I checked the "About Mach3" in the drop down menu and it shows me as the licensed user/owner off this software, so thats not it.

I've been through the manual I there is no mention of anything other than "fill in the boxes" and your good to go.  What am I doing wrong or haven't initialized in order to run the wizards.

Thanks
John W.

 

Title: Re: Help with the wizards
Post by: ger21 on June 20, 2009, 11:09:56 PM

Hit "Enter" after typing in the number.

"Doh"  ;)

Title: Re: Help with the wizards
Post by: John W on June 21, 2009, 12:11:50 AM

"DOH" :-[

Thank You.

John