Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: demonduster on June 17, 2009, 09:57:24 AM
-
As I'm pretty new to this and as my brain is getting pretty fried from
going to school for cnc programming - figuring our BobCad and Mach3
I'm sure I'm missing something simple somewhere.When I try to change
the display mode it does nothing (stays the same) maybe in my home
switches???????? or what???????????????????
Thank You ----- Rod
-
The display mode will only change to table view if you have told Mach the size of your table. To do that you set SoftLimits and have them enabled.
Hood