Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Mikkef on June 11, 2009, 05:41:36 PM

Title: I need help with Mach3 setup.......
Post by: Mikkef on June 11, 2009, 05:41:36 PM
Hello,

I need some help to get the basic settings in Mach3. I have a Xylotex 3 axis driver board and Win XP SP3.

I need help with settings so I can get contact with my control cards, etc..


I hope there is someone who can help me with this... Thank's



I have these settings:

Port 1 Enabled
Kernel Speed 25000Hz


X axis step pin = 2  Dir pin = 3
Y axis step pin = 4  Dir pin = 5
Z axis step pin = 6  Dir pin = 7

   
Reset button blinks " Emergency Mode Active " nothing happens whether I press the button..?
Status: External EStop Requested.

How do I best be this problem ..?




Sorry for my English spelling ... I am from Sweden ....


Regards
Mikael
Sweden
Title: Re: I need help with Mach3 setup.......
Post by: Hood on June 11, 2009, 05:55:44 PM
Go to Config menu then Ports and pins then Inputs, scroll down and change the active state of the E-Stop.
Hood
Title: Re: I need help with Mach3 setup.......
Post by: Mikkef on June 13, 2009, 11:15:51 AM
Hi,
Thank's Hood.... The Reset button is OK now...

I need also help so I can get access to my step motors....


/Mikael
Title: Re: I need help with Mach3 setup.......
Post by: Hood on June 13, 2009, 01:02:06 PM
What is your problem with the motors?
Hood