Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: wawatobi on August 17, 2006, 04:45:54 PM
-
Mach 3 will not run with my DeskProto dongle attached to the computer. The program thinks I hit the e-stop button. Also, Deskproto does not
recognise the dongle if my mill driver is attached to it. Anybody have this problem?
-
Try using a Printer A-B switch.
-
Or you can add a second printer port
-
I have another printer port but I guess deskproto doesn't know where it is and I don't know how to set the location in deskproto.
-
Put Mach3 on the second port.