Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Oscarl on June 04, 2009, 01:36:39 PM

Title: Looking for Analog DC-drives to use to an DSPMC controller!
Post by: Oscarl on June 04, 2009, 01:36:39 PM
Hi.

I have just bought my self an 4-axis to my mill from Tsudakoma.
Inside this NC table there were an Yaskawa DC motor.

Model: UGJMED-60M
450 watt
1000rpm
98V
6.0A
ARM R 1.45 Ohm

I wounder if there is some kind of drive that i can use for this motor that has analog input so i can use it to an DSPMC controller?

Best Regards
Oscar Larsson