Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: berty on June 03, 2009, 04:42:35 AM
-
I am still in convertion and setting up stage with lathe and occasionally i use it in manual to do small jobs
I tried to use the OD facing wizard but the machine gave a perfect tapper cut the when tool approached next cut the depth of cut stayed the same
I think it must be an offset problem but I am at a loss where to look for it
Maybee some one knows the answer
Cheers Bert
-
Can you post the code that is getting put out please, I have used the wizard before and it worked fine but it was a long time ago.
Hood
-
I will try to post it
cheers bert